-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueBreaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
10 Fundamental Rules of High-Speed PCB Design, Pt. 1
Over the years, I have focused on high-speed design, signal and power integrity, and EMC design techniques in a plethora of published technical articles—all of which have key points to consider and present a tremendous amount of information to absorb. In my next few columns, I will elaborate on ten of the most important considerations to embrace to achieve successful high-speed PCB designs that perform reliably to expectations.
Figure 1 lists the 10 fundamental rules of high-speed PCB design that I deem the most important to follow, although they may change after months of deliberation, like what happened with the laws of thermodynamics. The first established thermodynamic principle, which eventually became the second law, was formulated by Sadi Carnot in 1824. By the late 1800s, three laws of thermodynamics were clearly defined. However, in the 1930s—long after these three laws were already widely accepted—Sir Ralph Fowler and E.A. Guggenheim felt that another law, which they saw as the foundation of earlier laws, should be incorporated. Hence, it was numbered the zeroth law. Thus, there is always room for one more at the top!
To read this entire column, which appeared in the September 2018 issue of Design007 Magazine, click here.
More Columns from Beyond Design
Beyond Design: The Art of Presenting PCB Design CoursesBeyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities
Beyond Design: Balancing Trade-offs for Optimal PCB Design